Eagle Electronics Cuda 128 Portable User Manual
Page 52
48
DEPTH UNITS OF MEASURE
This unit can show the depth in feet or meters.
To change the depth units of measure, press
MENU DOWN
until the
U
NITS
menu appears. Use the arrow keys to select
the desired unit of measure, then press the
PWR
key to clear
the menu.
PRESET UNIT (reset all options)
This command is used to reset all features, options and settings to their
original factory defaults. This is useful when you have changed several
settings and want to return the unit to basic automatic operation.
Turn the unit off. Press and hold the
DOWN ARROW
key and the
MENU
DOWN
key at the same time while you press the
PWR
key. Release the
keys as the unit powers up. The unit will turn on with factory settings
restored.
SYSTEM INFO
To show the operating software system information, press
MENU DOWN
until the
U
NIT
I
NFO
menu appears. Press
PWR
to
clear the screen.
SIMULATOR
This unit has a built-in simulator that shows a simulated
bottom signal with fish signals. This lets you practice with
the unit as if you were on the water; all features and
functions of the unit are usable. A message appears
occasionally to remind you that the simulator is on.
To use the simulator, press
MENU DOWN
repeatedly until the
S
IMULATOR
menu appears. Press
UP ARROW
to turn it on, and press
PWR
to clear
the menu. Repeat the above steps to turn it off, or you can simply turn
the unit off and back on again.