Operation – Echo SRM-400 User Manual

Page 7

Advertising
background image

7

Oil

1

50

Gasoline

GENERAL CHECK

•

Eneure that all nuts, screws and bolts installed
are properly tightened.

FUEL STATEMENT

GASOLINE : Use 89 octane (

) gasoline or

gasohol known to be good quality. Gasohol may

contain maximum 10% ethyl (grain) alcohol or 15%
MTBE (methyl tertiary-butyl ether). Gasohol
containing methyl (wood) alcohol is not approved.

OIL : ECHO brand premium two-stroke 50:1 oil is
reguirred.
Mix oil and gasoline /gasohol according to
insturctions on the oil container label.
MIXING : Follow directions on the oil container.

OPERATION

R+M

2

US

METRIC

GAS

OIL

GAS

OIL

GAL

FL OZ

L

mL

1

2.6

4

80

2

5.1

8

160

5

12.8

20

400

Fuel mix chart

(50 : 1)

IMPORTANT

Stored fuel ages. Do not mix more fuel than
you expect to use in thirty (30) days, ninety
(90) days when a fuel stabilizer is added.
Stored two-stroke fuel may separata.
ALWAYS shake fuel container thoroughly
before each use.

STARTING COLD ENGINE

•

Slide switch to START/RUN position as shown.

•

Push purge bulb 3 or 4 times (or until constant
flow of fuel is visible in fuel return line.)

•

Move choke lever to COLD START (Close)
position.

•

Press the decompression device.

•

Pull recoil starter until the engine fires. Now,
move choke lever to RUN (open) position, and
if necessary, restart the engine again and allow
to warm up for a few minutes before using.

•

After idling, gradually open throttle and cutter
blade will start to operate as the engine attains
clutch engagement speed of 3,500 r/min
approximately.

Throttle trigger

Ignition switch

Throttle control lockout

Purge bulb

Fuel return line

Choke lever

NOTE

Recoil starter : Use short pulls - only 1/2 - 2/3 of
starter rope for starting. Do not let starter rope
snap back in .
Always hold the unit firmly.

COLD START (Close)

RUN (Open)

Advertising