Ericsson RX8000 Series - Manual (Page 99)

Chapter 3
2. Edit the parameter value as required using the W (Back) and X (Forward) keys
to select each digit in turn, and then using the S (Up) and T (Down) keys to
increment or decrement the digit.
3. Press Save to save the new settings or Edit to abandon the operation and
return to the current setting.
To edit the user STD:
1. Press the Edit key. The cursor appears below the first character of the current
STD selection.
2. Use the S (Up) and T (Down) keys to toggle between the MUS, AC3 (requires
RX8XXX/SWO/AC3), LINEAR (requires RX8200/SWO/4AUD), AAC (requires
RX8XXX/SWO/AAC) and HE-AAC (requires RX8XXX/SWO/AAC) options.
3. Press Save to save the new settings or Edit to abandon the operation and
return to the current setting.
This is the last of the Audio 1 options. To return to the Audio 1 menu, press the W
(Back) key.
3.5.6.3.2 3.3.2 – 3.3.6 Audio 2-6
The options for the Audio 2-6 menus are as detailed for the Audio 1 menu, see
above. Unless RX8200/SWO/4AUD is enabled, only Audio 1 and 2 will be available.
To return to the Audio menu and access the SDI Embedding menu, press the W
(Back) button.
3.5.6.4 3.4 SDI Embedding
To access the SDI Embedding options, press the T (Down) key, from the Audio
screen. The following screen is displayed:
AUDIO |SDI EMBEDDING
3.4 | >
3.5.6.4.1 3.4.1 CH1+2 Embedding
To view and edit the Channel Embedding options, press the X (Forward) key. The
following screen is displayed and the Edit key is lit:
CH1+2 |NO EMBEDDING
3.4.1 |---
To edit channel embedding:
1. Press the Edit key. The cursor appears at the start of the current option.
2. Using the S (Up) T (Down) keys toggle between the available options.
The available options depend on the RX82XX/SWO/4AUD licence. If enabled,
EN/LZT 790 0005 R1A 3-51