Echo U-HANDLE SRM-280S - Manual (Page 4)

U-H
andle
K
it
i
nstallation
i
nstrUctions
17. Place inner throttle cable in large hole of carburetor swivel (D).
18. Loosen nuts (C) and place threaded end of throttle linkage in
bracket slot. Finger tighten nuts (C).
19. Check throttle for freedom of movement and that wide open
throttle / low idle extremes are adjusted properly. If adjustment
cannot be achieved with adjusting nuts (C), consult with your
Echo Dealer for correct adjustment procedure. Tighten nuts (C).
20. Connect 2 ignition stop leads (A,B) from throttle cable tubing to 2
ignition leads (A,B) on engine.
21. Gather ignition wires and position behind air filter case.
22. Install air filter and cover
Install Hip Pad (Optional)
1. Attach hip pad to harness as shown.
A
B
A
B
4
D
C