Elo TouchSystems 1746L - Manual (Page 15)

STEP 4-Connecting the Power Cable
Depending on where you live, you will use either the European or US/Canadian
power cable.
• Connect the female end of the power cable to the
•
N OTE : To protect your equipment against risk of damage from electrical surges in the power
line, plug the touchmonitor’s power cord into a surge protector, and then connect the
surge protector to a grounded AC electrical outlet.
Brick power supply.
Connect the Brick power cable into the power port on the touchmonitor. •
Route the cable through the cable management channel.
POWER CABLE
ET1749L shown (ET1746L does not have DVI-D connector)
POWER
AUTO/SEL DOWN UP MENU
2-11