Epson Equity II - Manual (Page 92)

Note: If memory on an option board overlaps the computer’s main
memory, you must disable that part of memory-either on the
option board or on the built-in memory board. To reduce the
amount of main memory, you must use the Main option (of this
program) and also change a jumper on the built-in memory board.
You can find instructions for changing the jumper settings in your
User’s Guide.
To change the amount of memory, follow these steps:
1. On the main menu, press 1 to move the cursor block to Memory and
press Enter. This menu appears on the screen:
0 KB Expansion
** SAVE SETTINGS **
2. Press 1 and to move the cursor block to the setting you want to
change: Main or Expansion.
3. When the cursor block is on the Main option, this message appears at
the bottom of the screen:
return to main menu, select option, Enter
change main memory size
Press Enter to change between the possible amounts of main memory.
You can set the amount of main memory to 256KB, 512KB, or 640KB.
4. When the cursor block is on the Expansion option, this message appears
at the bottom of the screen:
s e l e c t o p t i o n , + or - change expansion
memory size
Press + to increase or press - to decrease the amount of expansion
memory. You can set the amount of expansion memory in increments of
64KB within the range from 0 to 15,360KB.
5. When your memory settings are correct, move the cursor block to
** SAVE SETTINGS **. You see this prompt:
s e l e c t o p t i o n , Enter set memory size
Press Enter to set the new memory size and return to the main menu.
Diagnostics 1-3