Enterasys Networks 700 - Manual (Page 65)

Managing the Module 2-45
The MultiSwitch 700 Device View
UPS ID
Displays the manufacturer and model typecode of the UPS attached to the COM
port of the MultiSwitch 700. You must assign this typecode for the UPS window
to be active. (See
Setting the UPS ID , on page 2-46 , for instructions for setting the
typecode for your UPS.) The valid typecodes are:
• Model 370
• Model 400
• Model 600
• Model 900
• Model 1250
• Model 2000
• Matrix 3000
• Matrix 5000
• SU 700
• SU 1400
• SU 2000XL
• Other
UPS Uptime
Displays the number of hours that the UPS has been operating since the last time
it was started up.
Line Voltage
Displays the voltage coming through the line attached to the MultiSwitch 700.
Battery Output
Displays the amount of battery output voltage.
Battery Capacity
Displays the percentage of remaining battery capacity (100% indicates a fully
charged battery).
Test Results
Displays the result of the last self-test performed by the UPS. The possible test
results are:
Unit OK The UPS unit is in working order.
Unit Failed The UPS unit has failed the self-test. Check the
unit for damage or consult your UPS User’s
Manual.
Bad Battery The UPS unit battery is bad.
No recent test No UPS self-test has been performed in the last
five minutes.
Unit in test... The UPS is currently in test mode.
Please standby