Electro-Voice MS3000 - Manual (Page 8)

MS3000 OWNERS MANUAL
page 8
Weight: 2.06 lb/1.06 kg
MSH Handheld Transmitter
Power Output: 10 mW terminated, 50-mW maximum
Antenna: Internal (patented)
Modulation: FM, +40 kHz Deviation w/50 us pre-emphasis
Frequency Response: 50 Hz to 15,000 Hz
Transducer: Electro-Voice N/D767 Supercardioid (MSHD)
Electro-Voice BK-1 Cardioid Electret (MSHC)
Supplied Accessory: Stand adapter
Battery: 9 volt alkaline
Approvals: FCC, Part 74H
Industry Canada RSS123
FCC Identification: B5DH211
Size: 10.75 in long (27.3 cm) x 2 in (5.08 cm) max.
Weight (MSHD) 284 g (10 oz) without battery
Weight (MSHC) 246 g (9.6 oz) without battery
MSB Bodypack Transmitter
Power Output: 10 mW terminated, 50-mW maximum
Antenna: Permanently attached
Modulation: FM, +40 kHz Deviation w/50 us pre-emphasis
TA4F Connector: Pin 1: Ground; Pin 2: Mic Input;
Pin 3: +5 volt bias; Pin 4: +5 volt bias fed through a 3 K
ohm resistor for 2-wire electrets
Frequency Response: 50 Hz to 15,000 Hz
Microphone Input Sensitivity: 7.8 mV for full deviation
DC Power: 9 volt alkaline battery
Approvals: FCC, Part 74H
Industry Canada RSS123
FCC Identification: B5DB108A
Size (HxWxD): 4.5 in x 2.6 in x 1.25 in (no antenna)
(114.3 cm x 66 cm x 31.75 cm)
Weight: 3.5 oz (480 grams) without battery
AVAILABLE ACCESSORIES
Model Part # Description
ULM20 ULM20 Electro-Voice cardioid lavalier microphone
CS200EX Electro-Voice cardioid lavalier microphone
CO2EX Electro-Voice omnidirectional lavalier
CM-311 E3K Crown differoid headset microphone
HM2 Electro-Voice cardioid headset microphone
HM1 Electro-Voice cardioid headset microphone
879155 ULM20 windscreen
Figure 13—TA-4F Connector Wiring
Pin 1 = ground
Pin 2 = mic input
Pin 3 = +5 volt bias
Pin 4 = +5 volt bias fed through 3K resistor for 2-wire
electrets
Figure 13