Epson 821p - Manual (Page 42)

42 Projecting
3. Press the P Power button again. The lamp turns off, and the
Power light flashes orange for about 20 seconds as the projector
cools down. When the projector has cooled, it beeps twice to
indicate that power is off. The
Power light stays orange and the
exhaust fan shuts off.
If you want to turn the projector on again, wait until the orange
light stops flashing. Then press the P
Power button.
4. Press up on the blue foot release lever and lower the projector to
retract the front adjustable foot, as shown.
5. Replace the lens cap and unplug the power cord.
6. Turn off and disconnect any equipment plugged into the
projector.
note
When the projector has not
received any input signals for
30 minutes, it automatically
turns off the projector lamp
and enters “sleep mode.” This
conserves electricity, cools the
projector, and extends the life
of the lamp. If you are done
using the projector, unplug
the power cord. If you want
to start projecting again, press
the P
Power button. You
can turn sleep mode on or off
through the Extended menu.
See page 59.
caution
To avoid damaging the
projector or lamp, never
unplug the power cord
when the Power light is
green or flashing orange.