Harbor Freight Tools 113 - Manual (Page 4)

Page 4
SKU 113
Warning: The warnings, cautions, and instructions discussed in this instruction manual
cannot cover all possible conditions and situations that may occur. It must be under-
stood by the operator that common sense and caution are factors which cannot be built
into this product, but must be supplied by the operator.
Operation
For best service you should incorporate an oiler, regulator, and inline filter,
as shown in the diagram above. Hoses, couplers, oilers, regulators, and filters
are all available at Harbor Freight Tools.
1. You will need to prepare a 1/4” - 18 air connector (sold separately) to connect to the air
inlet on the Saw. First, wrap the 1/4” air connector (not included) with pipe thread seal
tape before threading it into the Air Inlet (9). Connect the 3/8” ID Air Source Hose to the
Saw.
Note: If you are not using an automatic oiler system, before operation, add a few drops of
Pneumatic Tool Oil to the airline connection. Add a few drops more after each hour of
continual use.
2. Set the air pressure on your compressor to 90 PSI. Do not exceed the maximum air
pressure of 90 PSI.
3. Check the air connection for leaks. Disconnect the tool from the air source.
WARNING: Some dust created by power sanding, sawing, grinding, drilling, and other construction
activities, contain chemicals known [to the State of California] to cause cancer, birth defects or other
reproductive harm. Some examples of these chemicals are:
-
Lead from lead-based paints
- Crystalline silica from bricks and cement or other masonry products
- Arsenic and chromium from chemically treated lumber
Your risk from these exposures varies, depending on how often you do this type of work. To reduce
your exposure to these chemicals: work in a well ventilated area, and work with approved safety
equipment, such as those dust masks that are specially designed to filter out microscopic particles.
(California Health & Safety Code 25249.5, et seq. )
Unpacking
When unpacking, check to make sure the parts listed on page 7 are
included. If any parts are missing or broken, please call Harbor Freight Tools at
the number on the cover of this manual as soon as possible.
Saw
1/4” - 18 NPT
REV 08c