Assembly – Husqvarna 115 247227 R1 User Manual

Page 11

Advertising
background image

11

ASSEMBLY

CAUTION

Raise and hold deflector shield in upright position.

1.

fit lower chute as shown and hook rear latch to

2.

mower deck.
Align the bracket slot on lower chute with the

3.

deflector bracket tab on the mower deck. Slide
chute down over tab.
With the lower chute in proper position, hold the

4.

chute securely while hooking the front latch to the
mower deck.

NOTE: While hooking the latches, the deflector
shield may try to push the chute away from the
mower deck opening. It is important to hold the
chute in position while hooking the latches to
the mower deck.

6

LOWER CHUTE INSTALLATION

Deflector

Shield

Deflector

Bracket

Tab

Rear Latch

Front Latch

5

CONTAINER MOUNTING

Install containers on supports, overlapping at

1.

center supports.
Close cover and lock latch handles over center

2.

support tubes.

Center

Support

Tubes

WARNING

DO NOT operate mower unless
container is properly installed.
Container is subject to wear and
deterioration, check containers
frequently, replace when cracked or
damaged. Use only a recommended
replacement container.

CAUTION

Before raising deflector shield, turn
mower engine off. DO NOT remove
deflector shield from mower. Raise
and hold shield when attaching lower
chute and allow it to rest on chute
while in operation.

8063-009

8063-038

Advertising
This manual is related to the following products: