Husqvarna 115 247227 R1 - Manual (Page 9)

9
ASSEMBLY
1
BAGGER MOUNT - 2009 Models
Install the bagger mount tube to the rear guard 1.
with 5 /
16
-18 x 3¼ bolts and flange nuts from kit.
NOTE: Depending on model, rear guard hole may
need to be drilled out to
5 /
16
" if kit hardware is too
large.
Install kit support straps on the outside of the
2.
mount tube as shown in the illustration. Using
a
5 /
16
-18 x 1¼ bolt, attach the front side of the
strap to the fender support. Do not add flange
nut at this time. Place the reinforcement plate to
the outside of the fender support. Secure with
additional 1¼ bolt and fasten both bolts with
flange nuts. Repeat steps on opposite side.
NOTE: The front side of the kit support straps
should be on the inside of the mower frame.
Tighten all hardware. 3.
Reinforcement
Plate
Support Strap
Drill rear guard hole
to 5 /
16
" if needed
Remove rear engine guard (if installed) by removing
the six bolts that attach the guard to the frame.
Place hitch on the rear of the mower. 1.
Rear Engine
Guard
Engine
Guard
Bolts
Engine
Guard
Bolts
Install two of the previously removed bolts through 3.
rear of the hitch weldment.
Secure the sides of the hitch to the frame with
4.
5 /
16
-18 x ¾ bolts and washers from the new
hardware, (two per each side).
Previously
Removed
Hardware
Hitch
Mount Tube
8063-044
8063-045
8063-046
BAGGER SUPPORT -2008 and Prior Models