Hitachi DH 40FB - Manual (Page 19)

19
English
(2) Taper shank adaptor
3. Large-dia. hole boring (Rotation + Hammering)
4. Crushing (Hammering)
5. Groove digging and edging (Hammering)
6. Asphalt cutting (Hammering)
7. Digging
8. Syringe (for chip removal)
NOTE:
Specifications are subject to change without any obligation on the part of the
HITACHI.
(Guide plate)
Code No.
985388
955169
(2) Core bit
External dia.
2" (50 mm)
4-1/8" (105 mm)
(1) Center pin
Code No.
955165
(3) Core bit shank
(Spline shank)
Taper shank adaptor formed
A-taper or B-taper is provided as
optional accessory, but drill bit for
it is not provided
Code No. 985377
Code No. 985378
A-taper
B-taper
(1) Bull point
Overall length Code No.
12" (300 mm) 985383
(1) Cold chisel
Overall length Code No.
12" (300 mm) 985381
18" (460 mm) 985382
(1) Cutter
Overall length Width Code No.
12" (300 mm)
1-1/2" (38 mm) 985384
2" (50 mm) 985385
(1) Scoop
Code No. 985386
Code No. 944575