Hunter Fan 42999 44050S - Manual (Page 15)

FIGURE 3 FIGURE 4
■ Be sure to tighten the terminal screws securely, otherwise a loose wire could cause operational
problems with your system or thermostat.
■ Push excess wire back into hole to prevent interference with mounting of the thermostat cover.
■ Make sure the Function Switch is set at OFF, and the FAN-AUTO Switch is in AUTO.
■ Insert the bottom tab on the thermostat body into the slot at the bottom of the wallplate.
Press top of the thermostat body to snap it into the wallplate. (NOTE: Do not force the
thermostat onto the wallplate, as the terminal pins may be damaged. If it does not
snap properly, the thermostat may not work.)
■ Insert the two AA size batteries, observing the polarity
marked on the unit.
■ Switch on the main power. Press the reset button.
(See Figure 5.)
■ The LCD display indicates the current room temperature
of your house. If it shows random numbers or partial
digits, press the reset button once again.
■ The installation is now complete. Continue reading
Owner’s Manual for complete operating instructions.
W RC RH Y G
RH
RH
HEAT OFF COOL AUTO FAN RESET
FIGURE 5