Harbor Freight Tools 98089 - Manual (Page 9)

SKU 98089 For technical questions, please call 1-800-444-3353 PAGE 9
Throttle Trigger (10D): 9. Controls the Engine speed. Pulling back on the Throttle
Trigger opens the throttle and the Engine accelerates. Releasing the Throttle Trig-
ger slows down the Engine.
Rear Handle (7D):
10. Use to securely hold the Cut Off Saw when operating.
Filter Cover lock lever (13e): 11. Locks the Air Filter Cover (1E). Pull back on the
Filter Cover Lock Lever to open the Air Filter Cover.
Pre-Filter 1 (2e), Pre-Filter 2 (3e), Filter Housing (4e), Paper air Filter (5e),
12.
Secondary Filter (6e): Filters the air, preventing dirt and debris from entering the
Carburetor (7C).
Choke lever (5C): 13. Turning this Lever counterclockwise closes the Carburetor.
Use the Choke Lever to prime the Engine (cold starting). Turn clockwise for nor-
mal operation.
Starter Grip (3a):
14. Pull to start Engine.
Fuel Tank Cap (16C): 15. Open this Cap for filling the Fuel Tank (2C, 10C). Close the
Fuel Tank Cap prior to for starting and operation.
Decompression Valve (7B):
16. Press down on this Valve to make starting easier.
When air pressure in the Engine reaches a preset value, the Valve automatically
closes.
Belt Tensioner with Tensioning nut (35F):
17. For V-Belt tension adjustment. Turn
the Nut clockwise to loosen the V-Belt. Turn the Nut counterclockwise to add more
tension to the V-Belt.
Muffler (9B):
18. Reduces both noise and emissions.
Blade Guard Positioning Knob (38F): 19. Loosen the Knob to adjust the Blade
Guard (19F) position.
Shaft lock (34F):
20. Press and hold the Shaft Lock to facilitate Saw Blade (23F)
changing and installation.
Trigger Safety lever
21. (16D): This lever must be depressed in order for the engine
to start.
Foot Plate (26C)
22. : Place foot on plate while starting engine.