Harbor Freight Tools 91142 - Manual (Page 7)

SKU 91142 For technical questions, please call 1-800-444-3353. Page 7
Use
4. Pick up the Spray Gun (2A) and point it away from you. Squeeze the Trigger Handle
until all internal air is released, and a steady flow of water comes out. Release the
Trigger Handle.
5. Move the Choke Lever (C) to the closed (left) position. See engine photo below.
6. Turn the Fuel Valve (D) to the open (down) position.
7. Move the Throttle Control Lever (E) 1/3 to the left.
8. Turn the red Power Switch (F) to the ON position.
9.
Gasoline Tank (B)
Choke Lever (C)
Fuel Valve (D)
Throttle Control Lever (E)
Power Switch (F)
Starting Handle (G)
Pull the Starting Handle (G) lightly until you feel resistance. Then, pull it completely
out. The engine should start up. Slowly release the Starting Handle. Make sure the
Pressure Washer is on a level surface so it does not roll.
10. Adjust the Throttle Control Lever (E) for the desired speed and subsequent output
water pressure. Open the Choke Lever (C) to the right.
If the engine does not start after a few tries, refer to
Troubleshooting Tips on the next page.
11. Hold the Spray Gun (2A) with both hands and begin
spraying.
Do not allow the engine to run for more the three minutes
without spraying. Adjust the Spray Gun Nozzle (13A) to
the desired spray pattern.