HP LASERJET 3600 - Manual (Page 15)

20. At this point, reverse steps 7 on down. This will have the printer back up and running.
Remember to correctly thread the cables through the wire harnesses properly!
NOTE: The connector to the top cover is different between the simplex and
duplex models. The duplex has a larger connector, while the Simplex is
much smaller.
If you experience the following issue after installing the new cartridge locks, here?s how to
troubleshoot:
AISS Main Drive Ass'y (MDA) rework possible side-effects
Possible Failures After
Rework
Troubleshooting
13.01.00/13.02.00 Check connection 1 (see #1 in Figure 1)
Close Top Cover/ Close Front
Door
•
Check connection 4 (see #4 in Figure 1)
•
Check connection 3 (see #3 in Figure 1)
Insert or Close Tray 2 Check connection 2 (see #2 in Figure 1)
•
10.92.XX
•
Noise From Main Drive
Assembly
•
PQ-defect (i.e.: wrong
color, Missing color
pane, process CPR)
Check the cartridge bottom lock (see #5 in Figure 2)
Remove the MDA and check all the Gears Alignment and
correct as instructed. (for details, see steps 16 and 17 above
and re-check the MDA alignment as shown in Figure 3 below)
For noise specifically, check the Cartridge Drum Sensors on
the MDA (see Figure 4)