HONDA HARMONY FG100 - Manual (Page 31)

UNPACKING
1. Carefully remove the tiller and loose parts from the carton.
2. Remove the loose parts bag. Compare the loose parts with the inventory list below.
Tools Required:
Phillips screwdriver, 7/16 inch wrench (2), and 3/8 inch wrench.
LOOSE PARTS
Check all loose parts against the following list. Contact your your dealer if any of the loose parts shown
below are not included with your tiller.
* The tine spacers (item 20) are installed for narrow cultivating (see page 16).
** The drag bar (item 21) is installed in place of the wheel assembly prior to tilling (see page 9).
Ref. No Description Qty.
1 Upper Handle 1
2 Lower Handle, Right 1
3 Lower Handle, Left 1
4 Grip 2
5 Wheel Support 1
6 Wheel 2
7 Knob, Handlebar 2
8 1/4-20 x 4 1/2 inch Bolt 2
9 Wheel Washer 2
10 Wheel Spacer 2
Ref. No Description Qty.
11 Lock Pin 3
12 Clevis Pin 1
13 5/16-18 x 1 1/2 Handlebar Bolt 2
14 1/4 inch Curved Washer 8
15 1/4 inch Locking Nut 3
16 Tie Strap 2
17 1/4-20 x 2 inch Flange Bolt 1
18 Pipe Plug 1
19* Tine Spacer 2
20** Drag Bar 1
1 2 3 4
5 6 7 8
9 10 11 12 13 14
15 16 17 18 19 20
ASSEMBLY
FG100 TILLER
29