HONDA HARMONY FG100 - Manual (Page 32)

TILLER ASSEMBLY
1. Install the wheel spacers on the wheel support.
2. Install the wheels on the wheel support.
3. Retain each wheel to the wheel support with a
wheel washer and lock pin.
4. Install the wheel assembly to the bracket
assembly using the clevis pin and a lock pin.
Set the wheel height in the second hole from
the top as shown.
After the assembly is completed, select one of
the four holes that provides the most comfort
when transporting the tiller (see page 12).
5. Install the left and and right lower handles to
the transmission engine mount with the two
1/4-20 x 4 1/2 inch bolts, four curved washers
and two 1/4 inch locking nuts. Do not tighten
the mounting bolts at this time.
The left and right lower handles are identified
by the different lengths from the end of the pipe
to the mounting bolt hole as shown.
WHEEL (2)
WHEEL
SPACER
WHEEL WASHER
LOCK PIN
WHEEL WASHER
WAR NING
• REA D THE OWNER'S MANUA L CAR EFULL Y BEFORE OPERA TION.
• KNOW LOCA TION AND FUNCT IONS OF ALL CONT ROLS.
• KEEP ALL SAFETY DEVICES AND SHIELDS IN PLA CE AND WORKING.
• NEVER ALLOW CHILDREN OR UNINSTRUCT
ED ADUL TS TO OPERA TE MA CHINE.
• SHUT OFF ENGINE BEFORE MANUA LLY UNCL OGGING TINES OR M AKING REP AIRS.
• KEEP BYST ANDERS AWAY FROM MA CHINE.
• KEEP AWAY FROM ROT ATING PARTS WHILE ENGINE IS RUNNI NG.
• USE EXTREME CAUTION WHEN REVERSING OR PULLING
THE MACHINE TOWA RDS
YOU.
TO AVOID SERIOUS INJUR Y
BRACKET
CLEVIS
WHEEL
LOCK
5 1/4 in
(135 mm)
1 in
(25 mm)
LEFT
LOWER
RIGHT
CURVED
1/4 inch
1/4-20 x 4 1/2
TRANSMISSIO
N ENGINE
ASSEMBLY
30
FG100 TILLER