Hitachi MK-96RD626-07 - Manual (Page 147)

Using Spreadsheets for Universal Volume Manager Operations 6-7
Hitachi Universal Storage Platform V/VM Universal Volume Manager User’s Guide
The following table shows the parameters that can be set for the
AddVolumeSetting tag.
Table 6-7 AddVolumeSetting Tag Parameters
Layer Column
in
Spread
sheet
Parameter Setting Range of
Values
Number of
Characters
The first layer Information about external volumes and the primary path.
A PathGroup Path group number. 0 to 63231 5 decimal
digits or
less
B Port Port number of the primary path. 1A to GR 2 digits or
less
C WWN WWN of the primary path. 00000000
00000000
to FFFFFFFF
FFFFFFFF 16
hexadecim
al digits
D LUN LU number set to the external volume. 0000 to
0FFF 4
hexadecim
al digits or
less
E ExG External volume group number and its
sequential number. The format should be
EGrp-VPG (for example, E16384-4096).
GrP: 1 to
16384
VPG: 1 to
4096 GrP: 5
decimal
digits or
less
VPG:4
decimal
digits or
less
F Attribute ƒ Normal: Maps an external volume.
ƒ R-CMD: Maps a command device.
ƒ Normal
ƒ R-CMD
N/A
G CLPR CLPR that is used to access the external
volume.
0 to 31 2 decimal
digits or
less
H Emulation Emulation type of the external volume.
Write the same characters as the emulation
type shown in Table B-2. N/A 16
characters
or less in
ASCII
format
I CacheMod
e ƒ Enable: Sets cache mode to Enable.
ƒ Disable: Sets cache mode to Disable.
ƒ Enable
ƒ Disable
N/A
J InflowCon
trol ƒ Enable: Sets inflow control to Enable.
ƒ Disable: Sets inflow control to Disable.
ƒ Enable
ƒ Disable
N/A
The second layer Information about alternate paths. Specify the paths in the order of
descending priorities.
A + Identifier. N/A N/A
B Port Port number of the alternate path. 1A to GR 2 digits or
less