HP 3300mfp User Manual
Page 203
EN
Interpreting the configuration page 201
Subnet Mask
The IP subnet mask configured on the print server. During initialization, a
temporary value 0.0.0.0 is displayed. Depending on configuration
parameters, the print server may automatically assign a usable default
value.
●
Not Specified
a subnet mask is not configured.
Default Gateway
The IP address of the gateway used when sending packets off the local
network. Only one default gateway may be configured. During initialization,
a temporary value 0.0.0.0 is displayed. If not provided, the IP address of the
print server is used.
●
Not Specified
a default gateway is not configured.
Config By
Identifies how the print server obtained its IP configuration.
●
BOOTP
automatic configuration via a BOOTP server.
●
BOOTP/TFTP
automatic configuration via a BOOTP server and TFTP
configuration file.
●
DHCP
automatic configuration via a DHCP server.
●
DHCP/TFTP
automatic configuration via a DHCP server and TFTP
configuration file.
●
RARP
automatic configuration via the Reverse Address Resolution
Protocol.
●
User Specified
manual configuration via Telnet, the printer’s
control panel, HP Web JetAdmin, embedded web server, or other
method.
●
Default IP
the default IP address was assigned. This address may
not be a valid address for your network.
●
Not Configured
the print server was not configured with IP
parameters. Verify that TCP/IP is enabled, or check for error status.
BOOTP Server
or
DHCP Server
or
RARP Server
Displayed if BOOTP, DHCP, or RARP is used for TCP/IP configuration. It
specifies the IP address of the system that responds to the print server’s
request for automatic TCP/IP configuration over the network.
●
Not Specified
the configuration server’s IP address could not be
determined or was set to zero in the response packet.
BOOTP/DHCP Server
Displayed during initialization while the print server attempts to obtain its
TCP/IP configuration from a BOOTP or DHCP server. The temporary
address displayed is 0.0.0.0.
●
Not Specified
the configuration server’s IP address could not be
determined or was set to zero in the response packet.
TFTP Server
The IP address of the system where the TFTP configuration file is located.
During initialization, the temporary address 0.0.0.0 is displayed.
●
Not Specified
a TFTP server has not been set.
Config File
The name of the print server's configuration file. The file pathname may be
truncated to fit on two lines.
●
Not Specified
a file was not specified in the BOOTP reply from the
host.
Message
Description