Hoover 500 - Manual (Page 5)

To install brushes, place handle in
upright position. Tilt cleaner back so
that it rests on the floor.
Align post (A) on brush block with hole
(B) on bottom of cleaner. Turn brushes
slightly until post fits easily into hole.
Align control rod (B) on upper han-
dle (C) with slot in bottom handle
support (D).
Push upper handle (C) down until
it is snapped in place.
Rotate bottom handle support (A)
up to the upright position until a
snap is felt.
5
Assemble handle 2
2
4
3
5
4
Install brushes and nozzle 5 B
A
Continued ➜
C
B
D
C
A
3