Hitachi 51UWX20B - Manual (Page 4)

ACCESSORIES
4
1. Remote Control Unit CLU-4321UG (Part No. HL01831).
2. Two “AA” size, 1.5V batteries (For Remote Control Unit).
REMOTE CONTROL BATTERY INSTALLATION AND REPLACEMENT
1. Open the battery cover of the remote control by pushing the notched part of the cover with your fingers and pulling the
cover off.
2. Insert two new “AA” size batteries for the remote control. When replacing old batteries, push them towards the springs
and lift them out.
3. Match the batteries to the (+) and (-) marks in the battery compartment.
4. Replace the cover.
BOTTOM VIEW
Lift up on tab to
remove back cover.
Check to make sure you have the following accessories before disposing of the packing material.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace with the same or equivalent type.
CAUTION: Television stand models SP-43W and SP-43WS are designed for use with a 43 inch or smaller television set.
Use of a smaller stand, a non Hitachi recommended stand or a generic stand may result in instability, causing
possible injury.
1 2 3
4 5 6
7 8 9
0 ANT INFO
VOL CH
POWER
TV CBL/SAT DVD/VCR
PIP
SWAP PIP MODE
FREEZE
VIDEO
PIP CH
MENU
MUTE EXIT
LAST CH
REC ASPECT VIRTUAL HD
SELECT
PART NAME PART NO. ILLUSTRATION
CLU-4321UG
REMOTE CONTROL
HL01831
1. 2.
43” TELEVISION
STAND
SP-43W
(Not included,
order separately)
OPTIONAL
H530052
CLU-4321UG
VID1 VID2 VID3 VID4
VID5
43” TELEVISION
STAND
SP-43WS
(Not included,
order separately)
OPTIONAL
H530053