Heath Zenith SL-4300 - Manual (Page 6)

6 598-1208-00
SYMPTOM
Light stays on
continuously.
Light flashes on
and off.
Light does not
stay on in
Manual mode.
POSSIBLE CAUSE
1. There is a heat source like an air
vent, dryer vent, or brightly-
painted, heat-reflective surface
in the coverage area.
(Install
shield on sensor in the direction
of heat source.)
2. Light control is in Manual Mode.
(Switch to Auto.)
3. Light control is in Dual Brite™
mode.
1. Sensor is in the Test mode.
(While in TEST mode, light only
stays on for 5 seconds.)
2. Heat being reflected from other
objects may be affecting the
sensor.
(Re-aim sensor.)
1. Nearby large, light-colored ob-
jects reflecting light may trigger
the shut-off feature. Do not point
other lights at the sensor.
POSSIBLE CAUSE
1. Light switch is turned off.
2. Bulbs are loose or burned out.
3. Fuse is blown or circuit breaker
is turned off.
4. Daylight turn-off is in effect (re-
check after dark) .
5. Incorrect circuit wiring, if this is
a new installation.
1. Sensor may be installed in a
relatively dark location.
2. Sensor is in Test. (Set control
switch to an ON-TIME position.)
1. Sensor may be sensing small
animals or automobile traffic. (Re-
duce sensitivity.)
2. Sensitivity is set too high. (Re-
duce sensitivity.)
SYMPTOM
Light will not
come on.
Light comes on
in daylight.
Light comes on
for no apparent
reason.
TROUBLESHOOTING GUIDE
If you experience a problem with your porch light, follow this guide before returning it to the retailer.
No Service Parts Available for this Product
See your Canadian Tire retailer for warranty information.