Husqvarna 115 145727 - Manual (Page 8)

9
ASSEMBLY
4
CONTAINER INSTALLATION
Install containers on support frame, overlapping 1.
containers at center tube.
Note: One container should always overlap the
other container at the center tube.
Close cover and lock latch handle over support
2.
tubes.
Support
Frame
Latch Handle
WARNING!
DO NOT operate mower unless
container is properly installed.
Container is subject to wear and
deterioration, check containers
frequently, replace when cracked or
damaged. Use only a recommended
replacement container.
Raise and hold deflector shield in upright position. 1.
Fit lower chute as shown and hook rear latch to 2.
mower deck.
Align the bracket slot on lower chute with the
3.
deflector bracket tab on the mower deck. Slide
chute down over tab.
With the lower chute in proper position, hold the
4.
chute securely while hooking the front latch to the
mower deck.
NOTE: While hooking the latches, the deflector
shield may try to push the chute away from the
mower deck opening. It is important to hold the
chute in position while hooking the latches to
the mower deck.
5
LOWER CHUTE INSTALLATION
Deflector
Shield
Deflector
Bracket
Tab
Rear Latch
Attach Rear Latch here
Front Latch