Husqvarna 966529103 - Manual (Page 8)

8
Make sure the tension release lever is forward 1.
(disengaged).
Place the belt over the pulley on the deck. Refer
2.
to illustration for proper routing.
Move the tension release arm to the rear and
3.
engage in the latch.
4
INSTALLING DRIVE BELT
Rear of Deck Idler Pulleys
Outer Pulley
Twist in Belt
Tension
Release Arm
8063-074
5
INSTALLING BELT COVERS
Place the deck belt shield on the deck over the 1.
drive pulley and secure with hardware removed
from steel belt shield.
Place retainer on the outer pulley cover.
2.
Align the tab end of the belt cover into the slot on 3.
the deck belt shield and the other end over the
end of the outer pulley cover.
Secure with knob.
4.
Retainer
Outer Pulley Cover
Deck Belt Shield
Belt
Cover Tab
8063-079
Position upper chute support against bagger inlet, 1.
flush at outer edges. See Illustration.
Using support as a template, drill two
2. 3 /
8
holes into
bagger hood.
Bagger Inlet
Flex Trim
Secure upper chute support to hood with hex 3.
bolts, washers and nyloc nuts. Use the illustration
for hardware orientation.
Slide the flex trim over the support and bagger
4.
edge.
6
INSTALLING CHUTE SUPPORT
Upper Chute
Support
Upper Chute
Support
8063-047
8063-048
ASSEMBLY