Honeywell DOLPHIN 9951 User Manual
Page 16
2 - 2
Step 2. Charge the Main and Backup Batteries
The power supply for Dolphin terminals consists of two types of battery power: the main battery pack
installed on the back panel and the backup battery that resides inside the terminal.
The main battery powers the terminal. The internal backup battery charges off the main battery and
maintains the application data stored in RAM memory for up to 30 minutes when the terminal’s main
battery pack is completely discharged or removed.
Before Initial Use
Terminals are shipped with both batteries discharged of all power. Charge the main battery pack
for a minimum of 4.5 hours before initial use.
Time to Charge
Initial charging time for the main battery pack is 4.5 hours and 8 hours for the internal backup
battery. Connect the terminal to one of the 9000 series charging peripherals to charge; see
Peripherals for the 9900, 9950, and 9951
We recommend use of Honeywell peripherals, power cables, and power adapters. Use of any non-Honeywell
peripherals, cables, or power adapters may cause damage not covered by the warranty.
Step 3. Boot the Terminal
The terminal begins booting as soon as power is applied and runs by itself. Do NOT press any keys or
interrupt the boot process. Only tap the screen when prompted.
When the boot process is complete, the Today screen appears, and the terminal is ready for use.
Note: Because, the Today screen appears a number of times during the boot process, wait a few seconds before
tapping anything on the Today screen.
Step 4. Set the Time and Date
You need to re-set the time and date after every hard reset of the terminal. It is a good idea to set the time
and date before you begin using the device.
On the Today screen, tap the line that displays the time and date,
Note: The following warnings apply to 99XXXXX-XXXXXXI units (Hazardous Location rated. See
Replace only with battery pack type 200002586 manufactured by Honeywell International Incorporated.
Warning: Explosion Hazard. Charge or replace the battery only in an area known to be non-hazardous.
Warning: Explosion Hazard. Do not replace components unless power has been switched off or the area
is known to be non-hazardous.
Warning: Substitution of any components may impair suitability.
Warning: Explosion Hazard. Do not use external connectors in areas known to be hazardous.
!
!
!
!
!
!