Heath Zenith Motion Sensing Coach Lights - Manual (Page 5)

5 598-1207-01
❒ Caulk fixture mounting surface with
silicone weather sealant. You may want
to wait until you have completed the tests
and adjustments on page 6.
❒ Install one 100 W max. light bulb.
Slide the fixture onto the
mounting screws and
tighten nuts.
Junction
Box
COMPLETE THE
INSTALLATION
❒ Stuff the wires into the junction box. Make
sure the wires from the fixture go through
the wire path, and no wires get pinched.
TESTING
❒ Turn on the circuit breaker and light
switch.
30 ft.
(9.1m)
Maximum Range Maximum
Coverage Angle
6 ft.
(1.8 m)
Avoid aiming the control at:
• Pools of water or objects that change
temperature rapidly, such as
heating vents
and air conditioners. These heat sources
could cause false triggering.
• Areas where pets or traffic may trigger
the control.
• Nearby large, light-colored objects reflect-
ing daylight may trigger the shut-off feature.
Do not point other lights at the sensor.
Note: Sensor has a 1 1 /
2
minute warm up pe-
riod before it will detect motion. When
first turned on wait 1
1 /
2
minutes.
150°
TEST 1 5 10 MIN
ON-TIME
OFF 3 6 DUSK TO
HOUR DAWN
❒ Switch the on-time to TEST position and
D
ual
B
rite
® switch to the OFF position.
Note: Meets the ENERGY STAR ® guidelines
when D
ual
B
rite
® function is off.