Harbor Freight Tools 92917 - Manual (Page 5)

Page 5 For technical questions, please call 1-800-444-3353. SKU 92917
93253
c. Use only the lubricants supplied
with the tool or specified by the
manufacturer.
Air source
a. Never connect to an air
source that is capable of
exceeding 200 PSI. Over
pressurizing the tool may
cause bursting, abnormal operation,
breakage of the tool or serious injury
to persons. Use only clean, dry,
regulated compressed air at the rated
pressure or within the rated pressure
range as marked on the tool. Always
verify prior to using the tool that the
air source has been adjusted to the
rated air pressure or within the rated
air-pressure range.
b. Never use oxygen, carbon dioxide,
combustible gases or any bottled
gas as an air source for the tool.
Such gases are capable of explosion
and serious injury to persons.
SAVE THESE
INSTRUCTIONS.
SPECIFIC SAFETY
INSTRUCTIONS
1. Operators and others in work area
MUST wear ANSI-approved safety
goggles with side shields during
use. The employer is responsible to
enforce the use of eye protection by
the operator and others in the work
area.
2. Keep fingers away from trigger
when not driving fasteners to
avoid accidental firing.
3. Choice of triggering method is
important. Check manual for
triggering options.
4. Always assume the tool contains
fasteners.
5. Do not point the tool toward yourself
or anyone whether it contains
fasteners or not.
6. Do not actuate the tool unless the
tool is placed firmly against the
workpiece.
7. Respect the tool as a working
implement.
8. No horseplay. This tool is not a toy
and can be deadly if misused.
9. Do not load the tool with fasteners
when any one of the operating
controls, such as the Trigger or
Safety Nosepiece, is activated.
10. Do not remove, tamper with, or
otherwise cause the tool operating
controls to become inoperable.
11. Do not operate the tool if any portion
of the tool operating controls is
inoperable, disconnected, altered, or
not working properly.
12. Disconnect the tool from the air
supply when:
a. Unattended.
b. Performing any maintenance or
repair.
c. Clearing a jam.
d. Moving the tool to a new location.
13. Do not make any modifications to this
tool.
14. Refer to the tool maintenance
instructions for detailed information