Harbor Freight Tools BUNKER HILL SECURITY 68332 - Manual (Page 19)

SKU 68332 For technical questions, please call 1-800-444-3353 Page: 16
Mobile
Click [Main menu→Device→Mobile]
to enter into [Mobile] menu.
USER NAME: Enter the user name of the DVR.
USER PASSWORD: Enter the user password of the DVR.
SERVER PORT: Enter the mobile monitoring port.
Setting range is between 1024 and 65535.
Note: Connect the DVR to the Internet before setting the
DVR port number and the server port number. Consult
your mobile provider for additional information.
PTZ Setup (Pan/Tilt/Zoom)
(PTZ cameras not included)
Click [Main Menu→Device→ PTZ Setup]
to enter the PTZ Setup menu.
Select the channel you want to control and set PTZ
protocol (Pelco-D or Pelco-P), Baud Rate (1200, 2400,
4800, 9600), Stop bit (1, 2), Parity Check (None,
Odd, Even Mark Space), and Address Code.
Note: The above mentioned channel settings
must match the settings of the PTZ camera.
Set CRUISE to ON to enter the sub menus
that adjust the individual camera settings.
Click Z+&Z- keys to zoom In or out, click F+&F- keys
to control camera focus and click I+&I- to adjust iris.
CRUISE SETUP
Click CRUISE SET to open the auto cruise
function window if you want to adjust the cruise
function. The system default is ON.
CH#: Select the channel number with the PTZ camera
TOTAl: Enter presetting bit quantity.
CUR POINT: System has default starting
(current) cruise point as 01. You can use this
option to set additional cruise points.
STOP TIME: Adjust the pause time at each stop.
GOTO: Select this option to go to specific preset points.
SET: Saves the preset point. After setting channel
and setting the position by adjusting PTZ direction
key click SET to setup the pre-set point. Please
note you need to click SAVE to finish the setup
successfully. If you want to combine Zoom, Iris, Focus
and direction keys into the pre-set setting, return to
previous menu to add additional settings, and then
enter into Cruise Set again and click SET and SAVE
to make sure your setting is setup successfully.
ClEAN: Removes settings.
Note: This DVR model supports up to 100 pre-
set points. But actual quantities may be restricted
by the PTZ camera you are using.
Note: To save changes, you must press APPLY.