HP 5/xx Series 4 - Manual (Page 55)

English 43
3 How to Install Accessories In Your PC
Installing Mass Storage Devices
8 Align the drive with the holes in the bottom of the PC. Support the
drive with your hand while securing the drive with the four screws
provided.
9 Support the power supply with your hand and very carefully return
the PC to the upright position.
10 Connect the data and power cables to the rear of the drive.
The connectors are shaped to fit one way only. If you are not sure
which connector to use, refer to “Connecting an IDE Device to a Data
Cable” on page 39.
11 If a device was removed from the middle shelf, replace it.
12 If no device was removed from the middle shelf, replace the RFI
bezel.
Power cable Data cable
uno.bk : uno3_ins.fb4 Page 43 Monday, July 21, 1997 12:46 PM