HP C4680 - Manual (Page 12)

To load an original on the glass
1.
Lift the lid on the HP All-in-One.
2. Load your original print side down in the right front corner of the glass.
Tip For more help on loading an original, refer to the engraved guides
along the edge of the glass.
3. Close the lid.
To load 10 x 15 cm ( 4 x 6 inch) photo paper in the input tray
1.
Remove all paper from the input tray.
2. Insert the stack of photo paper into the far-right side of the input tray with the
short edge forward and the print side down. Slide the stack of photo paper
forward until it stops.
If the photo paper you are using has perforated tabs, load the photo paper so that
the tabs are closest to you.
Tip For more help on loading small-size photo paper, refer to the guides
engraved in the base of the input tray for loading photo paper.
3. Slide the paper-width guide inward until it stops at the edge of the paper.
Do not overload the input tray; make sure the stack of paper fits within the input
tray and is no higher than the top of the paper-width guide.
Basics Guide 9
HP All-in-One
overview