HP DL385 - Manual (Page 62)

Hardware options installation 62
7. Install the expansion board.
8. Lock the PCI retaining clip.
9. Install the PCI riser cage (" Installing the PCI riser cage " on page 31 ) if you installed the expansion
board in slot 3.
10. Connect any required internal or external cables to the expansion board. Refer to the documentation
that ships with the expansion board for details.
11. Close the PCI riser cage door.
12. Install the access panel (" Installing the access panel " on page 29 ).
13. Power up the server (on page 27 ).
External simplex SCSI cable option
The external SCSI cable configuration allows the unused SCSI port on the system board to be routed
externally through a PCI slot. This option is only available if the server is operating in simplex mode.
1. Power down the server (on page 27 ).
2. Extend the server from the rack (on page 28 ).
3. Remove the access panel (" Removing the access panel " on page 29 ).
4. Remove the front fan bracket (" Front fan bracket " on page 32 ).
5. Remove the PCI riser cage (" Removing the PCI riser cage " on page 31 ).
6. Install the external simplex SCSI cable.
CAUTION: Always route the optional external simplex SCSI cable to avoid interference with the fan
assembly or PCI riser cage installation.