Homelite UT10516/16 IN. 33CC - Manual (Page 32)

Page 
INSPECTING/CLEANING THE SPARK
ARRESTOR SCREEN
See Figure 1.
The muffler is equipped with a spark arrestor screen. A faulty
spark arrestor screen can create a fire hazard. Through normal
use the screen can become dirty and should be inspected
weekly and cleaned as required. Always keep the muffler
and spark arrestor on the saw in good condition.
WARNING
Muffler surfaces are very hot during and after operation
of the chain saw. To avoid serious personal injury, keep
all body parts away from the muffler.
 Allow the muffler to cool.
 Remove the cylinder cover to gain access to the deflector
where the spark arrestor screen is located.
 Remove the deflector retaining screws.
 Lift the deflector to access the spark arrestor screen.
 If dirty, clean the spark arrestor screen with a small wire
brush. Replace the screen if it is cracked or otherwise
deteriorated.
INSPECTING ANd CLEANING CHAIN bRAKE
See Figures  - .

Remove the clutch cover and clean the chain brake
components. Check wear on the brake band and replace
if worn or deformed. The band thickness should not be
less than 0.024 in., or worn halfway through.
 Always keep the chain brake mechanism clean and lightly
lubricate the linkage.
 Always test the chain brake performance after servicing or
cleaning. Refer to
Operating Chain brake for additional
information.
 Check the chain catcher and replace if damaged.
WARNING:
Even with daily cleaning of the mechanism, the depend-
ability of a chain brake to perform under field conditions
cannot be certified. Keep the SAFE-T-TIP nose guard on
the saw’s guide bar and use proper cutting techniques.
STORING THE PROdUCT
 Clean all foreign material from the product. Store it in a
well-ventilated place that is inaccessible to children. Keep
away from corrosive agents such as garden chemicals
and de-icing salts.
 Abide by all Federal and local regulations for the safe
storage and handling of gasoline.
MAINTENANCE
Fig. 71
Fig. 73
Fig. 72
When storing 1 month or longer:

Drain all fuel from tank into a container approved for
gasoline.
 Run the engine until it stops. This will remove all fuel-oil
mix that could become stale and leave varnish and gum
in the fuel system.
 Squeeze primer bulb several times to purge fuel from
carburetor.
 Drain all bar and chain oil from tank into a container
approved for oil.
muFFler
Spark arreStor
SCreen
deFleCtor
deFleCtor
retaining
SCrew
nutS
Brake Band
Clean the Chain Brake
luBriCate the Chain
Brake linkage
Chain CatCher