HONDA F220 - Manual (Page 22)

20
OPERATION
HONDA F220 (E) 00X31-V14-6120 -
Tiling Depth Adjustment
The drag bar is used to control the
tilling depth, which can be adjusted
by removing the pin and retainer
and sliding the drag bar up and
down as necessary.
During operation, if the machine
jerks forward while tilling, press
down on the handlebars. This will
cause the drag bar to dig more
deeply into the soil.
Front Wheel
After getting to the tilling site, move the front wheel to the raised position
before tiling. Always stop the engine before lowering or raising the wheel.
To raise or lower the wheel, pull out the wheel assembly, move the wheel,
then release the wheel assembly.
RETAINER
PIN
DRAG BAR
TILLING POSITION
TRANSPORT POSITION
FRONT WHEEL
F220_EN.book 20 ページ ２０１０年２月１２日 金曜日 午前１１時２分