Husqvarna 340 - Manual (Page 49)

48 – English
4
Fit and tighten the six crankcase bolts to a torque
of 8–10 Nm. Check that the crankshaft rotates
freely.
5
Refit the following parts:
• bark rest
• oil pump*
• chain tensioner
• centrifugal clutch*
• fuel tank*
• piston and cylinder*
• generator*
• carburettor base
• carburettor*
• throttle pushrod
• silencer*
• ignition system*
• starter assembly*
• cylinder cover
• clutch cover
• guide bar and chain
* See special instructions.
NOTE!
If a new crankshaft has been fitted the
saw must be run in for 3-4 hours with the
carburettor adjusted to the factory set-
tings.
Crankshaft complete 340, 345, 350 –
reassembly
1
Fit the crankshaft complete in the crankcase.
350:
Fit and tighten the four bolts holding the spacer
from underneath and fit the crankshaft complete in
the crankcase.
Refit the following parts:
• piston and cylinder*
• fuel tank*
• silencer*
• carburettor*
• throttle pushrod
• centrifugal clutch*
• generator*
• ignition system*
• starter assembly*
• cylinder cover
• clutch cover
• chain and bar
* See special instructions.
Repair instructions