Husqvarna 1827EXLT - Manual (Page 20)

20
FIG. 27
AXLE
KLIK PIN
HOLE
TRACK HUB
TRACK
SERVICE AND ADJUSTMENTS
TO REMOVE TRACKS (See Fig. 27)
• Remove the klik pin and remove track from axle.
ENGINE
See engine manual.
CARBURETOR
Your carburetor is not adjustable. Engine performance
should not be affected at altitudes up to 7,000 feet (2,134
meters). If your engine does not operate properly due to
suspected carburetor problems, take your snow thrower
to a qualified service center.
TO ADJUST CABLE TENSION (See Fig. 28)
Adjust cable tension by turning the adjuster turn buckle,
located on the right hand cable. Grasp the long section
tightly and turn the short section to lengthen the adjuster.
Adjust until cable is snug.
ADJUSTER TURN
BUCKLE
FIG. 28
ENGINE SPEED
Never tamper with the engine governor, which is factory set
for proper engine speed. Overspeeding the engine above
the factory high speed setting can be dangerous and will
void the warranty. If you think the engine-governed high
speed needs adjusting, contact a qualified service center,
which has proper equipment and experience to make any
necessary ad just ments.