Horizon Fitness CT81 - Manual (Page 6)

10
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE
YOU
BEGIN
TREADMILL OPERA
TION
LIMITED
W
ARRANTY
TROUBLESHOOTING
&
MAINTENANCE
CONDITIONING
GUIDELINES
11
INTRODUCTION
IMPORT
ANT
PRECAUTIONS
ASSEMBL
Y
BEFORE YOU
BEGIN
TREADMILL OPERA
TION
CONDITIONING GUIDELINES
TROUBLESHOOTING &
MAINTENANCE
LIMITED WARRANTY
ASSEMBLY STEP 3
FLAT WASHER (B)
CONSOLE MAST
CONSOLE CABLE
SPRING WASHER (H)
BOLT (G)
CONSOLE
DO NOT ATTACH
THIS SIDE UNTIL STEP 3-D
FLAT WASHER (D)
CONSOLE MAST
CONSOLE CABLES
SPRING WASHER (G)
BOLT (H)
CONSOLE
DO NOT ATTACH
THIS SIDE UNTIL STEP 3-D
FLAT WASHER (B)
20 mm
Qty: 4
SPRING WASHER (H)
15 mm
Qty: 4
BOLT (G)
20 mm
Qty: 4
HARDWARE BAG 3 CONTENTS :
A Open HARDWARE BAG 3.
B With running deck in lowered position, place CONSOLE on upright masts. Align the brackets
that are underneath the console with the top holes of the upright masts.
C To assemble the CONSOLE to the LEFT CONSOLE MAST, insert 1 BOLT (G),
1 SPRING WASHER (H) and 1 FLAT WASHER (B) into the 2 holes in the
LEFT CONSOLE MAST and lightly tighten.
D Gently lift RIGHT side of the CONSOLE to connect the CONSOLE CABLE. Carefully tuck wire
in mast to avoid damage. NOTE: Do not pinch console cable or grip pulse wires.
E Repeat STEP C above to assemble the RIGHT CONSOLE MAST to the CONSOLE.
F Leave console bolts loose until after STEP 4 is completed.
ASSEMBLY STEP 4
BOLT (I)
CONSOLE MAST
BOLT (G)
CONSOLE MAST
CROSS BAR
SUPPORT BAR
BOLT (I)
15 mm
Qty: 4
HARDWARE BAG 4 CONTENTS :
O A pen HARDWARE BAG 4.
A B lign SUPPORT BAR with holes in CONSOLE MASTS.
I C nsert BOLTS (I) into all 4 holes of the SUPPORT BAR.
NOTE: Look into holes in the right mast before inserting bolts to avoid pinching cables.
T
D ighten all console bolts (Step 3) and support bar bolts (Step 4) completely.
CT81_Treadmill_Rev.1.8.indd 10-11 5/29/07 8:51:33 AM