Honeywell 88037 - Manual (Page 6)

6
SETTING UP THE COMPACT REFRIGERATOR
UNPACKING
Remove all packing materials and accessories. Examine the compact refrigerator for any
damage such as dents or broken door. Do not install if the refrigerator is damaged.
Do not tilt the compact refrigerator at an angle of more than 45 degrees while
moving it.
NOTE: Allow the compact refrigerator to stand upright for approximately 24
hours before connecting the power source. This will let the compressor settle
from being handled during transportation.
Starting the compact refrigerator too soon and not allowing the compressor
to settle can result in a lack of cooling.
Also before operating, clean the refrigerator thoroughly. Wipe the outside with a soft
dry cloth and wipe the interior with a clean moist cloth.
If discarding an old refrigerator, please see “Disposal Instructions” on page 3.
LOCATION OF THE COMPACT REFRIGERATOR
Find a suitable area for your compact refrigerator. Do not place the refrigerator outside, or any
other place where the refrigerator will be exposed to water, sunlight, or other harsh weather
conditions. The refrigerator must not be placed in environments where the ambient
temperature drops below 10°C (50°F) degrees because it will not run often enough to
maintain the desired temperatures.
PLACEMENT INSTRUCTIONS
The compact refrigerator is a free standing appliance
and can be installed next to counters and walls. It
can not be placed under a counter.
For the compact refrigerator to function properly, it is
important to have a clearance of at least 15 cm (6”
inches) from the back of the compact refrigerator to
the surface next to it. A clearance of at least 10 cm
(4” inches) is required from each side of the compact
refrigerator to the surface next to it.
Top of
Refrigerator
back
front
wall
15 cm / 6” inches
10 cm /
4” inches
NOTE: THE SPACING IS NECESSARY FOR AIR CIRCULATION
10 cm /
4” inches
ADJUSTING THE LEGS OF THE REFRIGERATOR
The compact refrigerator has adjustable legs on the front of
the unit. These legs can be used to adjust the height and
stabilize the unit. To lengthen the leg, turn the leg counter-
clockwise and to shorten the leg, turn clockwise.
ADJUSTABLE LEG