HONDA HRR216VXA - Manual (Page 52)

TECHNICAL AND CONSUMER INFORMATION
50
EMISSION CONTROL SYSTEM
Source of Emissions
The combustion process produces carbon monoxide, oxides of
nitrogen, and hydrocarbons. Control of hydrocarbons and oxides of
nitrogen is very important because, under certain conditions, they react
to form photochemical smog when subjected to sunlight. Carbon
monoxide does not react in the same way, but it is toxic.
Honda uses lean carburetor settings and other systems to reduce the
emissions of carbon monoxide, oxides of nitrogen, and hydrocarbons.
The U.S., California Clean Air Act and Environment Canada
EPA, California and Canadian regulations require all manufacturers to
furnish written instruction describing the operation and maintenance of
emission control systems.
The following instructions and procedures must be followed in order to
keep the Honda engine emissions within the emission standards.
Tampering and Altering
Tampering with or altering the emission control system may increase
emissions beyond the legal limit. Some acts that constitute
tampering are:
• Removal or alteration of any part of intake, fuel, or exhaust system.
• Altering or defeating the speed-adjusting mechanism to cause the
engine to operate outside its design parameters.
Problems That May Affect Emissions
If you are aware of any of the following symptoms, have your engine
inspected and repaired by your authorized Honda servicing dealer.
• Hard starting or stalling after starting
• Rough idle
• Misfiring or backfiring under load
• Afterburning (backfiring)
• Black exhaust smoke or high fuel consumption