Fitting the handlebar, Transport position, handlebar, Assembly – Husqvarna 324RX User Manual

Page 13

Advertising
background image

ASSEMBLY

English

–

13

Fitting the handlebar

•

Remove the screw at the rear of the throttle handle.

•

Slide the throttle handle onto the right side of the
handlebar, (see diagram).

•

Align the screw hole in the throttle handle with the hole in
the handlebar.

•

Refit the screw in the hole in the rear of the throttle
handle.

•

Screw the screw through the handle and handlebar.
Tighten it.

•

Unscrew the knob from the handlebar mounting.

•

Position the handlebar as shown. Fit the mounting
components and tighten the knob lightly.

•

Put on the harness and hang the machine from the
support hook. Now make a final adjustment so that the
machine is in a comfortable working position when it
hangs from the harness. Tighten the knob.

Transport position, handlebar

•

The handlebar can easily be turned to fit along the shaft
for easier transportation and storage.

•

Loosen the knob. Turn the handlebar clockwise so that
the throttle handle rests against the engine.

•

Now twist the handlebar around the shaft. Tighten the
knob.

•

Fit the transport guard to the cutting attachment.

Advertising