HP MAILBUS 400 - Manual (Page 5)

Installing Component for Remote Access by XAPI Agents
Where an XAPI Agent (that is, an Agent using the MAILbus 400 Application
Program Interface) is to be installed on a system remote from the MTA, select
the option to install the MAILbus 400 MTA Base component on the single
node, or on one node in the cluster, where the Agent is to be installed.
After the Installation
The set-up tasks required after installation, and the MTA verification
procedure are described in Part III of HP MAILbus 400 MTA Planning and
Setup.
Before you set up each MAILbus 400 MTA that you have installed, make sure
that the Base component of the HP Enterprise Directory Service is installed on
each node or cluster where you intend to operate a MAILbus 400 MTA.
Refer to the HP Enterprise Directory Service documentation for details of how
to install the Base component of the HP Enterprise Directory Service.
Release Notes and Further Information
After installation, the release notes are kept in
SYS$COMMON:[SYSHLP]MAILBUS400_MTA.RELEASE_NOTES.
HP MAILbus 400 MTA Tuning and Problem Solving contains a list of the files
that should be present on your system after installation, and information about
how to contact HP if the installation fails.
3