Using image view, Overview, Requirements – Honeywell Dolphin Demos User Manual
Page 39: Configuring imageview on the workstation, Chapter 8 - using image view, Overview -1, Requirements -1, Configuring imageview on the workstation -1
8 - 1
8
Using Image View
Overview
Image View is a software installed on the host workstation and receives data via wireless connection from
the following Demos on the terminal:
• Imaging Demo
• IQ Imaging Demo
• Scan Demo
• Signature Capture Demo
Note: Contact your nearest Honeywell technical support office to retrieve the latest version of Image View.
Requirements
• Image View must be installed and configured on the host workstation.
• Both the Dolphin terminal and Image View on the host workstation must have the same IP address and
TCP port.
Configuring ImageView on the Workstation
1.
On the host workstation, click the ImageView.exe file and complete the installation process.
2.
Click File > Setup.
3.
In the IP Address field, enter the IP address of the host workstation.
4.
Use the default Decode Port and Image Port for the host workstation.
5.
Tap Apply. The network parameters are set.
6.
Now, you need to configure the Demos on the terminal.