Panasonic ER508 - Manual (Page 5)

8
upward to let it fully dry. (Fig.16)
4) Apply a few drops of the oil to the
points indicated by the arrows. (Fig.19)
5) Remount the blade on the clipper
body.
WARNING: Detach the clipper
from the AC adaptor before
cleaning it in water.
BIf cleaning with brush
1) Use the cleaning brush to brush
off the cut hairs from the clipper
body and from around the blade.
(Fig.17)
2) Remove the blade and brush off
the cut hairs from the blade edge.
3) Brush the cut hairs out from between
the fixed blade and the moving
blade. Press down on the lever for
cleaning in order to raise the moving
blade, and brush the cut hairs out
from between the blades. (Fig.18)
4) Apply a few drops of the oil to the
points indicated by the arrows. (Fig.19)
5) Remount the blade on the clipper
body.
Important notice
regarding environmental
protection
The built-in rechargeable Nickel-
Metal Hydride battery contains
substances which may be
environmentally harmful. Before
discarding your eletric hair clipper
please remove the battery and be
sure that it is disposed of in an
environmentally friendly way.
<How to remove the built-in
rechargeable battery>
Disconnect the clipper from the
outlet when removing the battery.
Fully discharge the battery.
1) Remove the blade A and then
remove the three screws. (Fig.20)
2) Remove the bodycorner (housing).
(Fig.21)
3) Remove the four screws. (Fig.22)
4) Remove the blade attachment
mounting Q and the lower cover R,
and then pull out the motor S.
(Fig.23)
5) Remove the plug mounting T, and
then take out the nickel metal hydride
battery. (Fig.24)
Be careful not to short the + and -
terminals of the battery after
removing it.
Specifications
Power source : 230V AC, 50Hz
Motor voltage : 1.2V DC
Charging time : 12hours
( )
( )