17 installation, Tile kit – Harman Stove Company Conquest Gas Stove User Manual
Page 17
17
INSTALLATION
Only For Qualified Installers
Tile Kit
Each tile kit contains six tiles and fifteen allen-
set screws. If the Conquest is installed as a top vent,
then the round tile is not used. If it is installed as a
rear vent, then the trim ring is not used.
Installing Tiles
Below each tile opening are three threaded
holes. In some cases it may be helpful to remove
extra paint from the treads with a 1/4-20 tap.
1. Screw the set screws down until the top of the
screw is about the thickness of the tile below the
top surface.
2. Place the proper tile in the opening.
3. Observe the level of the tile. If the level of the
tile is not satisfactory, remove the tile by press-
ing down on one of the corners and adjust set
screws accordingly.
Round Tile Not
Used On Top Vent
Trim Ring Not
Used On Rear
Vent.
Allen Set
Screws