Husqvarna BCZ3205DL - Manual (Page 10)

GB-10
BCZ3205DL / BCZ3205DW
INSTALLING HANDLE (BCZ3205DL)
• Mount the handle to the shaft tube and clamp it at a
location that is comfortable to you.
INSTALLING HANDLE (BCZ3205DW)
• Loosen the 4bolts on the upper cap and insert the
handle. Retighten the bolts securely.
CONNECTING THROTTLE WIRE (BCZ3205DL/DW)
1. Remove the air cleaner cover.
2. Connect the end of the throttle wire to the joint on the
top of the carburetor.
CONNECTING SWITCH WIRES (BCZ3205DL/DW)
• Connect the switch wires between the engine and the
main unit.
HIP PAD (BCZ3205DW)
• Wrap the hip pad around the shaft tube as shown in
the figure, and fasten the hooks.
INSTALLING CUTTING ATTACHMENT GUARD
FOR TRIMMER HEAD
• Attach the cutting attachment guard with the bolts
combined to the shaft tube while inserting the spacer
between the guard and the shaft tube.
6. Set up
INSTALLING TRIMMER HEAD
1. While locking the gear shaft by inserting the angled
bar(1) into the holder(A)(2) on the angle transmission,
loosen and remove the nut (left-handed).
2. Fit the trimmer head assembly to the gear shaft.
Tighten it securely by hand.
INSTALLING CUTTING ATTACHMENT GUARD
FOR METAL BLADE
• When using metal blade, make sure to remove the
guard skirt.
INSTALLING BLADE
1. Put the angled bar(1) into the side holes of the
holder(A)(2) and the angle transmission.
2. Remove the nut (left-handed) and the holder(B)(3)
from the gear shaft.
3. Put the blade onto the holder(A)(2). Make the marked
side face the holder.
4. Put the holder(B)(3) onto the gear shaft making the
recessed side face the blade.
5. Fasten the blade by the nut and the cover(4).
BALANCE UNIT
1. Put on harness and attach unit to harness.
2. Slide clamp up or down until unit balances with head
aparting from the ground when using it.
(1) About 33.5cm
(13.2 inches)