Seat assembly – Healthrider HRSY23080 User Manual
Page 16
16
40
21
19
17
89
48
68
40. Important: Follow all three Cables from end to
end and make sure they rest in the grooves of all
Pulleys and that both the Cables and the Pulleys
move smoothly. Attach the bolt at the end of the Low
Cable (72), the 1/2Ó Plain Nut (68), the 1 1/2Ó Flat
Washer (48) and the Adjustment Tube (89) to the
Weight Tube (17) in the order shown. Note: The bolt
at the end of the Low Cable is one of the means
for tightening the Cables (72, 73 and 92). Thread
the bolt into the Weight Tube until all Cables are
tight and rest firmly in the grooves of all Pulleys.
Then tighten the 1/2Ó Plain Nut (68) onto the 1
1/2Ó Washer (48).
Insert the Weight Pin (19) into one of the holes
between the Weights (21).
42
65
65
39
50
96
7
37
101
Welded Bushings
96
42. Press a 1Ó x 1 1/2Ó Inner Cap (96) into each end of
both Backrest Frames (37).
Identify the Right Backrest Frame (101) and the Left
Backrest Frame (37) by looking at the welded bush-
ings. Orient the Backrest Frames so the welded bush-
ings are facing the Seat Frame (7) and are on the
lower edge of the Backrest Frames. Attach the
Backrest Frames (37, 101) to the indicated hole in the
Seat Frame (7) with a 3/8Ó x 6 1/2Ó Bolt (65) and a
3/8Ó Nylon Locknut (50).
Attach the Backrest Frames (37) to the indicated hole
in the Backrest Adjustment Tube (39) with a
3/8Ó x 6 1/2Ó Bolt (65) and a 3/8Ó Nylon Locknut (50).
43
7
74
74
12
71
13
37
71
49
43. Attach the Backrest (12) to the Backrest Frames (37)
with four 1/4Ó x 2Ó Bolts (74) and four 1/4Ó Flat
Washers (71).
Attach the Seat (13) to the brackets on the Seat
Frame (7) with four 1/4 x 3/4Ó Bolts (49).
41
Bracket
47
7
39
51
38
98
50
41. Locate and open the parts bag labeled ÒSeat
Assembly.Ó
Press a 1 1/4Ó Square Inner Cap (98) into the indicat-
ed end of the Backrest Center Tube (38). Attach the
Backrest Center Tube to the bracket on the Seat
Frame (7) with a 3/8Ó x 2 3/4Ó Bolt (47) and a 3/8Ó
Nylon Locknut (50). Slide the Backrest Adjustment
Tube (39) onto the Backrest Center Tube (38). If nec-
essary, pull out the Short Adjustment Knob (51).
Seat Assembly
72