HHB comm PERSONAL COMPACT DISC RECORDER CDR 830 - Manual (Page 40)

40
7 Additional information
Troubleshooting
Below is a list of messages mainly related to playback and recording problems, together with a brief
explanation and a page reference where you can find more information:
Display messages relating to playback
Display Cause Remedy
NEW
DISC A blank disc is loaded. Only recording is possible on blank CD-R
or CD-RW discs. Playback is not
possible.
NO DISC An attempt is made to start playback without
loading a disc. Open the tray and check that a disc is
loaded.
Display Cause Remedy
CHECK
DISC The disc is damaged
or dirty.
The disc is loaded
upside down.
Take out the disc and check for dust, dirt, scratches, etc. Clean
as necessary.
Take out the disc and reload it label-side up. If the same
message is displayed again after the disc is reloaded, turn the
CDR-830 power switch off, and after a few seconds on again. If
the same message is still displayed, please contact a HHB
authorized service center.
CHECK
(blinking
display) A system error
occurred, perhaps
due to noise or static
electricity. Turn the CDR-830 power switch off, and after a few seconds
on again. If the same message is displayed again, please
contact a HHB authorized service center.