Storage – Husqvarna 917.37583 User Manual

Page 17

Advertising
background image

17

STORAGE

Immediately prepare your lawn mower for storage at the end of the season or if the unit
will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a
period of time, clean it thor oughly, remove
all dirt, grease, leaves, etc. Store in a
clean, dry area.
1. Clean entire lawn mower (See

“CLEANING” in the Maintenance sec-
tion of this manual).

2. Lubricate as shown in the Main te nance

section of this manual.

3. Be sure that all nuts, bolts, screws, and

pins are securely fas tened. Inspect
moving parts for damage, breakage
and wear. Replace if necessary.

4. Touch up all rusted or chipped paint

surfaces; sand lightly before painting.

HANDLE
You can fold your lawn mower handle for
storage.
1. Loosen the two (2) handle knobs on

sides of the upper handle and allow
handle to fold down to the rear.

2. Squeeze the bottom ends of lower

handle toward each other until pins in
handle clear the brackets and pivot
entire handle assembly forward and
allow it to rest on mower.

• When setting up your handle from the

storage position, you must manually
lock lower handle into mowing position.

IMPORTANT: When folding the handle
for storage or trans por ta tion, be sure to
fold the handle as shown or you may dam-
age the control cables.

Handle pin

Handle
bracket

SQUEEZE

FOLD
FORWARD
FOR
STORAGE

MOWING

POSITION

Lower handle

Operator
presence
control bar

Upper

handle

Handle

knob

3. Reinstall knobs and carriage bolts to

lower handle / handle brackets for safe
keeping.

• When setting up your handle from

the storage position, lower han dle will
require manually locking into mowing
position.

IMPORTANT: When folding the handle
for storage or transportation, be sure to
fold the handle as shown or you may dam-
age the control cables.

ENGINE

FUEL SYS TEM
IMPORTANT
: It is important to prevent
gum deposits from forming in essential
fuel system parts such as carburetor, fuel
fi lter, fuel hose, or tank during storage.
Alcohol blended fuels (called gasohol or
using ethanol or methanol) can attract
moisture which leads to separation and
formation of acids during storage. Acidic
gas can damage the fuel system of an
engine while in storage.
• Empty the fuel tank by starting the en-

gine and letting it run until the fuel lines
and car bu re tor are empty.

• Never use engine or carburetor cleaner

prod ucts in the fuel tank or permanent
damage may occur.

• Use fresh fuel next season.

Advertising