Husqvarna 115 24 05-95 - Manual (Page 11)

English
11
SWIVEL JOINT
1. Connect the blower and swivel joint with flexible hose. Clamp both
ends of the flexible hose securely with the hardware supplied with the
unit.
NOTE
A light lubricant may be used to ease assembly of flexible hose to
blower elbow.
THROTTLE LEVER
1. Set up the clamp to the swivel and tighten the screw on the clamp.
(1) Clamp
(2) Swivel
(3) Screw
THROTTLE CABLE
1. Use the clamp to fasten the colgate tube containing the throttle cable
and the power cable to the hose.
(1) Clamp
(2) Cable
(3) Hose
BLOWER TUBES
1. Align the protrusion and the groove provided on the tube ends and
twist the tube until the connection is locked.
NOTE
A light lubricant may be used to ease assembly of blower tube.
NOTE
If longer tube is required, the second straight pipe can be
connected with the first one.
If higher air speed is required, the round blow pipe can be replaced
by the concentrator nozzle.
(1) Concentrator nozzle (option)
HARNESS
NOTE
The harness must always be worn when working with the machine.
Failure to do so means you will be unable to maneuver safely and
this can result in injury to yourself or others.
A correctly adjusted harness and machine significantly facilitates the
work. Adjust the harness to give the best working position.
F1
F2
F3
(1)
F5
F4
F6
Assembly
150BT_US.fm Page 11 Friday, April 10, 2009 9:51 AM